|
|
| Author |
Message |
franciskus
Joined: 27 Mar 2006
Posts: 213
|
 Posted: 08/01/07 - 06:52 Post subject: |
 |
|
| Hello! I have bought new hard drive. it is bigger then my previous, so, i decided that it will be my main hard drive, and the old hard drive will be secondary one. I have attached them in my case and when I start computer, i just can see main hard drive and cannot see secondary. Why? |
|
|
Back to top
|
|
|
|
 |
donalt
Joined: 16 May 2006
Posts: 97
|
| Posted: 09/24/07 - 03:07 Post subject: |
|
|
| Hello! I think that you did not set jumpers properly on your slave drive. Turn of your computer, open your case and see how jumpers on your slave drive are set. To set them properly, you should use schema on top of your hard drive. You need to set them in slave mode (not cable select or master). |
|
|
Back to top
|
|
|
|
|
|
